SNOWJOE RJ207M Manual De Instrucciones página 3

EN
Roof Rake Head Assembly
The assembly of the roof rake head requires hardware (nuts
and bolts) included in the pack. Use the equipped open
wrench for nuts and the hex wrench for bolts. Make sure to
tighten the hardware connections for a secure assembly.
1. Depress the small buttons on the pole adapter and insert
the pole adapter into the connector on the back of the roof
rake head. Push firmly until the two small buttons pop up
in the holes on the connector (Fig. 1).
Fig. 1
Rake head
Connector
2. Align the holes of the metal braces with the hole on the
end of the pole adapter. Secure with the long bolt and one
nut (Fig. 2).
Fig. 2
Long bolt
3. Connect the metal braces to the rake head with 2 small
bolts and the remaining nuts, as shown (Fig. 3).
Fig. 3
Nuts
Metal braces
Pole adapter
Small buttons
Metal braces
Nut
Short bolts
Connecting the Poles
1. To connect the roof rake head assembly with the pole
handle, depress the small button at the end of the pole
handle and insert it into the end of the pole adapter. Make
sure the small button pops up in the hole on the pole
adapter so the assembly is secured (Fig. 4).
Fig. 4
Roof rake
head assembly
2. If additional reach is needed, connect the provided pole
extensions between the pole handle and the rake head
assembly. Make sure the small buttons pop up in the hole
on the pole so the assembly is secured (Fig. 5).
Fig. 5
Roof rake
head assembly
NOTE: Make sure the pole handle is the last piece of the
assembly.
NOTE: Only connect the minimum number of pole
extensions needed to reach the roof. This will minimize the
weight of the roof rake and reduce the effort required.
If you have any questions, please call the Snow Joe
Sun Joe customer service department at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
3
Small button
Pole handle
Pole Extensions Pole handle
+
®