Oven Rack Guide; Diffuser Tray Guide; Removing The Oven Door - Furrion FGR24D3A1A-SS Manual De Usuario

● The inside of the oven should preferably be cleaned after use,
when it is still warm, when it is still warm, with hot water and
soap; the soap should be rinsed away and the interior should be
dried throughly. Avoid using abrasive detergents (for example
cleaning powders, etc...) and abrasive sponges for dishes or
acids (such as limescale-remover, etc...) as these could damage
the enamel. If the grease spots and dirt are particularly tough
to remove, use a special product for oven cleaning by following
the instructions provided on the packet.
● If you use your oven for an extended period of time,
condensation may form. Dry it using a soft cloth.
● There is a rubber seal surrounding the oven opening which guarantees its perfect functioning. Check the condition of
this seal on a regular basis. If necessary, clean it and avoid
using abrasive products or objects to do so. Should it become
damaged, please contract your nearest After-sales Service
Center. We recommend you avoid using the oven until it has
been repaired.
● Never line the oven bottom with aluminium foil ,as the
consequent accumulation of heat could compromise the
cooking and even damage the enamel.
● Clean the glass door using non-abrasive products or sponges
and dry it with a soft cloth.

Oven Rack Guide

The oven rack features an anti-tip locking system.
● To remove the rack push inside fully, then unclip the rear tabs
from the locking channel by pushing upwards and pulling the
rack forward.
● To insert the oven rack, position the oven rack just above the
rack position desired. The rack should slide towards the back
and will drop down once fully pushed in. To lock the rack into
position, pull the rack forward slightly and then push the rack in
to lock down the front section of the rack. (Fig. 13)
Fig. 13

Diffuser Tray Guide

The diffuser tray is removable for cleaning, it is integrated with an
anti tip locking feature.
● To remove the diffuser tray - Pull the diffuser tray outward until both the rear tab and front tab from the locking system are
aligned to the 2 opening area of the embossed rail. Then unclip
these tabs by pushing upwards and sliding forward.
● To insert the diffuser tray, position it just above the lowest
position. The diffuser tray should slide towards the back and
will drop down once fully pushed in. (Fig. 14)
NOTE: The diffuser tray only can be used and placed in the lowest
position for correct function. Ensure it is flat after assembling it
back after cleaning.
Fig. 14

Removing the Oven Door

When removing the door:
● Do not place excessive weight on an open oven door or stand
on an open oven door as, in some cases, it could cause the
range to tip over, break or damage the door to the extent that
the range would be unsafe to use, or cause serious injury to the
user.
● When opening the oven door, allow steam and hot air to escape
before reaching in oven to check, add or remove food.
● Make sure oven is cooled down and powered off before
removing the door. Failure to do so could result in electrical
shock or burns.
● The oven door is heavy and fragile. Use both hands to remove
the oven door. The door front is glass. Handle carefully to avoid
breaking.
● Grasp only the left and right sides of the oven door. Do not
grasp the handle as it may swing in your hand and cause
damage or injury.
● Failure to grasp the oven door firmly and properly could result
Rack Position
in personal injury or product damage.
● To avoid injury from the hinge bracket snapping closed, be sure
that both levers are securely in place before removing door
(Fig. 15a). Also, do not force door open or closed - the hinge
Rack
could be damaged and injury could result.
Rack
1. Be sure to read the above WARNING before attempting to
remove oven door.
2. Open the door to its fully open position. (Fig. 15)
Fig. 15
- 12 -
WARNING
CCD-0005506 Rev: 08-16-22