Dust Extraction; Working With The Electric Power Tool; Service And Maintenance - Festool OFK 500 Q Manual De Instrucciones

English
NOTICE The pin [3-6] must be flush with the
grinding face (not at the circumference) of the
ball bearing guide.
7.3 Locking/unlocking adjusting ring
WARNING! Operate power tool only with locked
adjusting ring [1-6].
Locking
► Push locking slide [1-7] forward.
Unlocking
► Push locking slide [1-7] backward.
7.4 Setting the routing depth
► Unlock adjusting ring [1-6].
► Larger routing depth: Turn adjusting ring in
a clockwise direction.
Smaller routing depth: Turn adjusting ring
in an anti-clockwise direction.
► Lock adjusting ring.
Twist around a cut-out:
Routing depth change = 1 mm
7.5 Changing routing tool
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
► Unlock adjusting ring [1-6].
► Turn adjusting ring until the nose [3-4] of
the locking button [3-5] is opposite a cut-
out of the adjusting ring.
► Press locking button and turn routing
tool [3-2] until the locking button engages,
thereby locking the spindle. Press and hold
the locking button.
► Undo the screw [3-1] on the ball bearing
guide.
► Remove the routing tool [3-2].
► Insert new routing tool.
► Place screw [3-1] in ball bearing guide and
tighten.
► Release locking button and lock adjusting
ring.
7.6

Dust extraction

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
16
The angle adapter [1-1] acts as an adapter for
connection to a Festool mobile dust extractor.
► Place angle adapter [1-1] on the extractor
connector [1-2] of the guard.
► Insert adapter of a dust extraction
hose 27 mm into the angle adapter.
CAUTION! If an anti-static suction hose is not
used, static charge may occur. The user may
receive an electric shock and the electronics of
the power tool may be damaged.
8 Working with the electric
power tool
When working on the machine, observe
all of the safety warnings that are listed
at the start as well as the following rules:
– Only guide the power tool towards the
workpiece when it is switched on.
Wait until the power tool has come to a
–
complete halt before placing it down. The
insertion tool can get caught and lead to a
loss of control of the power tool.
– When routing, ensure that the power tool's
feed direction is the same as the tool's cut­
ting direction.
8.1 Routing
► Steadily guide the machine along the edge
of the workpiece. Ensuring that the guiding
table and the milling tool ball bearing are in
contact with the workpiece at all times.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the housing to be opened should al­
ways be carried out by an authorised serv­
ice workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1