Symbols; Safety Warnings - Festool OFK 500 Q Manual De Instrucciones

Contents
1 Symbols..................................................... 13
2 Safety warnings.........................................13
3 Intended use..............................................14
4 Technical data........................................... 15
5 Parts of the device.....................................15
6 Commissioning..........................................15
7 Settings......................................................15
8 Working with the electric power tool........16
9 Service and maintenance..........................16
10 Accessories............................................... 17
11 Environment.............................................. 17
12 General information.................................. 17
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating instructions and
safety instructions.
Wear ear protection.
Wear protective gloves when changing
tools!
Wear a dust mask.
Wear protective goggles.
Disconnecting the mains power cable
Connecting the mains power cable
Safety class II
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tip or advice
Handling instruction
UKCA marking: The United Kingdom
Conformity Assessed symbol is a
marking for products being placed on
the market in the United Kingdom. It is
a manufacturers indication that the
product is in conformance with the rel­
evant regulations in the UK.
2

Safety warnings

2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
2.2 Machine-specific safety notices
Hold the power tool by insulated gripping
-
surfaces only, because the cutter may
contact its own cord. Cutting a "live" wire
may make exposed metal parts of the pow­
er tool "live" and could give the operator an
electric shock.
Use clamps or another practical way to se­
-
cure and support the workpiece to a stable
platform. Holding the work by your hand or
against the body leaves it unstable and may
lead to loss of control.
- Operate power tool solely with properly in­
stalled guide table [1-12] and guard [1-3].
- Operate power tool only with locked adjust­
ing ring (see section 7.3).
- Only cutters provided by Festool for this
purpose may be mounted on the power
tool. The use of other cutters is prohibited
due to the increased risk of injury.
- Only use routers that meet standard EN
847-1. All Festool cutters meet these re­
quirements.
- Used tools must be approved for speeds of
at least 30,000 rpm according to EN 847-1.
Spindle [3-3] and screw [3-1] must not be
-
damaged.
- Do not work on the power tool if its elec­
tronics are defective as this may lead to ex­
cessive speeds. You can tell if the electron­
ics are defective if there is no smooth start-
English
13