VONROC PR501AC Traducción Del Manual Original página 9

• The vibration emission during actual use of the
power tool can differ from the declared total value
depending on the ways in which the tool is used;
• Need to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. Machine
2. Cable
3. Lock-off button
4. Right handle
5. Spindle lock
6. Vacuum cleaner attachment
7. Knob for parallel guide
8. Parallel guide rod
9. Baseplate
10. Anti scratch plate
11. Parallel guide
12. Bolt for parallel guide
13. Depth stop revolver
14. Collet nut
15. Knob for depth stop
16. Left handle
17. Speed adjustment wheel
18. Depth stop bar
19. Depth stop indicator
20. Depth stop fine adjustment knob
21. On/off switch
22. Clamping lever
23A. Collet 8mm
23B. Collet 6mm
24. Router bit
25. Template guide
26. Bolt
27. Centre pin
28. Wrench
29. Safety guard
30. Scale
WWW.VONROC.COM
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
Mounting and removing router bits (fig. B)
Only use cutters with a shaft diameter
which corresponds with the size of the
collet.
Only use cutters which are suited for the
maximum speed of the machine.
The cutter diameter should not exceed the
maximum diameter (see 'Technical
specifications').
The router bits included with this machine are
shown in the figure 'package contents'.
Never tighten the collet nut, if there is no router bit
in the collet; the collet may be damaged.
1. Remove the safety guard (29).
2. Keep the spindle lock button (5) pressed and
rotate the spindle until the spindle lock fully
engages.
3. Loosen the collet nut (14) using the wrench
(28) provided.
4. Insert the shank of the router bit (24) into the
collet (23) as shown on figure B. Make sure that
the shank protrudes at least 3mm from the collet.
5. Keep the spindle lock button (5) pressed and
tighten the collet nut (14) using the wrench
(28) provided.
Replacing the collet (Fig. B)
The correct size collet must be used for the
corresponding router bit (cutter) type.
1. Remove the safety guard (29).
2. Keep the spindle lock button (5) pressed and
rotate the spindle until the spindle lock fully
engages.
3. Loosen the collet nut (14) using the wrench
(28) provided.
4. Replace the collet (23).
5. Keep the spindle lock button (5) pressed and
tighten the collet nut (14) using the wrench
(28) provided.
EN
9