Machine Information; Technical Specifications - VONROC PR501AC Traducción Del Manual Original

EN
• Only use router bits with a shank diameter equal
to the size of the collet installed in the tool.
• The permitted speed of the cutting bit must be
at least equal to the maximum speed marked on
the powertool. If cutting bits run faster than their
rated speed, they may break and fly off.
• Never use router bits with a diameter exceeding
the maximum diameter specified in the technical
data section. Routers and other accessories must
be able to fit exactly in the tool holder (collet) of
your power tool. Application tools that do not fit
exactly in the tool holder of the power tool will
turn unevenly, vibrate heavily and may cause
a loss of control.
• Do not use the tool in an inverted position
when holding it. Do not attempt to use the tool
in a stationary mode, unless combined with
specifically designed accessories as a router table.
• Take special care when routing MDF or surfaces
coated with lead­based paint. Wear a dust mask
specifically designed for protection against lead
paint dust and fumes and ensure that persons
within or entering the work area are also protected.
• Do not let children or pregnant women enter the
work area.
• Do not eat, drink or smoke in the work area.
• Never rout over metal objects, nails or screws.
The router could become damaged and cause
increased vibration.
• Use suitable detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance. Contact
with electric lines can lead to fire and electric
shock. Damaging a gas line can lead to explosion.
Penetrating a water line causes property damage
or may cause an electric shock.
• Dispose of dust particles and any other debris
safely.
• Do not use blunt or damaged routers and router
bits. Blunt or damaged routers and router bits
cause increased friction, create imbalances and
may become jammed.
• This appliance is not intended for use by young or
infirm persons without supervision. Children must
be supervised to ensure they do not play with the
appliance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
8
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This product is designed for copy routing as well
as routing grooves, edges, profiles and elongated
holes in wood and wood products while resting
firmly on the workpiece. The router is intended for
use in domestic environments. The equipment is to
be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse. Before use,
check the machine, for loose parts and accessories
from transport damage.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No load speed
Cutting depth
Collet
Weight
Lpa (sound pressure)
Lwa (sound power)
Vibration
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 62841-1, EN 62841-2-17; it may be used to
compare one tool with another and as a preliminary
assessment of exposure to vibration when using
the tool for the applications mentioned:
• Using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
PR501AC
230V~
50 Hz
1200 W
16.000 - 30.000/min
55 mm
6 and 8 mm
3.6 kg
92.1 dB + 3 dB(A)
103.1 dB + 3 dB(A)
2.105 +1.5 m/s²
WWW.VONROC.COM