Cleaning And Maintenance - MSW -BIH-1500 Manual De Instrucciones

continuous operation
(from the moment of
pressing the heating
switch), the device
stopped heating.
After use, the outer
layer on the heating
tip flakes off over a
large area.
3.4.
a) Allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
Wait for the rotating elements to stop.
•
b) Use only non-corrosive cleaners to clean the surface (it is recommended to
use widely available, mild cleaning agents for the vehicles interior).
c) After cleaning the device, all parts should be dried completely before using it
again.
d) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
e) Do not spray the device with a water jet or submerge it in water.
f) Do not allow water to get inside the device through vents in the housing of
the device.
g) Clean the vents with a brush and compressed air.
h) The device must be regularly inspected to check its technical efficiency and
spot any damage.
i) Use a soft cloth for cleaning.
j) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a
metal spatula) because they may damage the surface material of the
appliance.
k) Do not clean the device with an acidic substance, agents of medical purposes,
thinners, fuel, oils or other chemical substances because it may damage the
device.
DISPOSING OF USED DEVICES
Do not dispose of this device in municipal waste systems. Hand it over to an
electric and electrical device recycling and collection point. Check the symbol on
the product, instruction manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings. By choosing to recycle
you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
tripped (the heater has
been disconnected).
The heating tip is worn.

Cleaning and maintenance

press it again after a few
seconds to continue working.
It is a normal wear of the
consumable element - replace
it with a new, functional one.