Working With The Wheel Clamp Module Control; Precondition For The Use Of The Wheel Clamp Module Control; Fixing The Wheel Clamp Module Control To The Vehicle - Hella Gutmann Radaufnehmer Control Instrucciones De Operación

3. | Working with the Wheel Clamp Module Control

3. Working with the Wheel Clamp Module Control
This section describes the use of the wheel clamp module Control.
3.1. Precondition for the Use of the Wheel Clamp Module
Control
Regard the following in order to use the wheel clamp module Control:
• Before parking the vehicle it has been driven 5 m straight ahead.
• Vehicle parked on even ground.
• Suspension system is not distorted.
• Front wheels are in straight-ahead position.
• Parking brake is not applied.
• Air suspension is set to normal level.

3.2. Fixing the Wheel Clamp Module Control to the Vehicle

WARNING
Sharp object
Risk of injury or piercing
Always use the handle to attach the wheel clamp module 1st GEN / wheel clamp module SE / wheel
clamp module WA and wheel clamp module Control to the rim flange or tire.
CAUTION!
Scratching of surfaces
Damage to wheel rims
Always attach the protective cylinder set to the rim flange or tire.
NOTICE
Attach the wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module WA and
wheel clamp module Control horizontally and centered to the wheel center.
Proceed as follows to attach the wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module WA
to the vehicle:
22
Hella Gutmann
Radaufnehmer Control