Planika KL21 Square Manual De Instalacion Y Uso página 8

Gas cylinder connection
Twist-on connection
1. Check if the bottle valve is TURNED OFF turning it
clockwise
2. Remove the protection tip and store it for later use.
3. Before making the connection check if the black seal is not
damaged.
4. Fit the connecting nut to the cylinder with the use of a
correct wrench or the connecting knob. (left thread) Do not
allow the gas bottle connectors to be fastened too tightly.
5. When the gas flow is required turn the valve of the bottle
counter-clockwise.
•
Place the gas bottle in a correct distance from the fireplace (min 1,5 metres away).
WARNING!!! Check the gas connection for leakage. If anything suggests a leak is present (for instance a
characteristic gas smell) close the gas bottle valve and under no circumstances turn the device on before removing
the leak. (See point 5.1).
•
After removing the leak one may open the gas bottle valve again.
1.
Remove the protection tip. Do not use any
tools, leave the tip hanging freely.
2. Make sure all the taps on the gas device are
closed and if the switch in in the OFF position.
3. Place the quick-release regulator on the valve
and press it down hard. If the switch is
correctly turned off you will hear a
characteristic click.
4. To let the gas flow in turn the switch into the
ON position (or into the flame image).
8
Quick-release