• GENERAL DESCRIPTION
1.
Nozzle
2.
Cover
3.
Water tank
4.
Control panel
5.
Base
6.
Ultrasonic transducer
7.
Air outlet
8.
Float 1
9.
Float 2
10. Remote control
• TECHNICAL DATA
− power: 25 W
− supply voltage: 220-240V ~ 50-60Hz
− capacity: 3,2 l
− output: 350 ml/h
− humidifier output for a 35m
− humidifier operation time for a full container: approx. 10 hours
• INTENDED USE
The ultrasonic humidifier NU10 is designed to improve air quality in living quarters. The appropriate level of air
humidity improves the well-being and quality of sleep. Natural air ionization, resulting from the breaking of
water particles, additionally cleans the humidified air and reduces the amount of bacteria present in it.
• USE
− Before use, check that the appliance is complete and undamaged.
− Do not place the appliance on a carpet, lining, parquet floor, or any surface which can be damaged by water
or moisture.
− Place the appliance on a hard and stable surface.
− When placing the appliance, make sure that the power plug is always accessible.
− The appliance should always be placed upright.
− Do not cover the air outlet and inlet.
− It is recommended to place the humidifier at a minimum height of 1 m from the floor.
CAUTION. Water fragrances (oils, etc.) CANNOT be used in the machine. Pouring oils into the reservoir (3)
or base (5) may damage the humidifier. This type of damage is not subject to warranty repair.
• OPERATION
− Make sure the appliance is turned off and disconnected from the power supply.
− Holding the tank (3) with one hand, remove the lid (2).
− Fill the tank (3) with water to the maximum level - Fig. 1.
− Put the lid (2) on the tank (3).
− Plug the appliance into the mains, complying with the parameters specified above. The appliance will enter
the standby mode. No function is active, and the display is switched off.
INSTRUCTION MANUAL
ULTRASONIC HUMIDIFIER NU10
• CONTROL PANEL (4) / REMOTE CONTROL (10)
A. ON/OFF
B. HUMIDIFY
C. HYGROSTAT
D. TIMER
E. DISPLAY
room
2
INSTRUCTION MANUAL
ULTRASONIC HUMIDIFIER NU10
EN
11