Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
2
► 1. Hex bolt 2. Outer flange 3. Diamond wheel
4. Inner flange 5. Protrusion (bigger side)
NOTE: If an inner flange is removed by chance,
install the inner flange so that its protrusion (bigger
side) faces inside as shown in the figure.
Hex wrench storage
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing water supply
Loosen the screw A.
Slide the tank holder all the way over the motor housing
so that the notch of the band (part of the tank holder)
is positioned just below the screw head of the tool as
illustrated.
Then tighten the screw A.
4
5
3
1
8 ENGLISH
5
4
2
► 1. Screw A 2. Tank holder 3. Motor housing 4. Notch
of the band (part of the tank holder) 5. Screw head
of the tool
Attach the tank on the tank holder so that the tank
holder fits between the step and dots. Connect the cap
on the tube end to the mouth of the tank. Turn the tank
clockwise. Then tighten the screw B.
1
3
2
► 1. Tank 2. Tube 3. Screw B
Water supply
CAUTION:
When filling the tank with water, be
careful not to let the tool get wet.
Be sure that the water supply cock is closed before
filling the tank with water. Open the cap on the tank and
fill the water. Recap the tank.
2
3
► 1. Water supply cock 2. Close 3. Open
1
3
2
1
3
Tabla de contenido
