Control Panel (Display); Assembly The E-Scooter; How To Unfold And Fold The Scooter - Olsson and Brothers UNIQUE Manual De Usuario Y Garantía

EN

6. CONTROL PANEL (DISPLAY)

Speed
3
indicator
Battery
4
indicator
Speed mode
5
indicator
On / off button: Keep button 3 pressed for several seconds until the screen turns
1
on / off.
Light on / off button: Press and hold button 2 on the multifunction display for several
2
seconds.
Speed indicator: Shows the speed of the scooter at that moment.
3
Battery level indicator:
Shows the battery level using 5 bars.
4
Speed mode indicator: Shows the speed mode.
5
PEDESTRIAN MODE (1)
Maximum speed of
6km/h
SPEED
Clear the total mileage: Press buttons 3 and 4 at the same time, then press the
power button and the total mileage will be cleared.
NOTE: uto power off / Power saving mode: After the screen is inactive for more
than 5 minutes, the electric scooter will go into power saving mode and turn off
automatically.
16
Increase speed
2
mode / Light on - off
1 On/Off
Decrease speed
6
mode
DRIVE MODE (2) SPORT MODE (3)
Maximum speed of Maximum speed of
15km/h 25km/h
BATTERY LIFE

7. ASSEMBLY THE E-SCOOTER

Unfold the electric scooter and place it on a smooth surface.
1 2
Attach the
clamp to the
handlebar
bar (without
tightening the
screws)
3 4
Tighten
the
screws
Your new E-Scooter must be assembled according to the steps above, as shown in the
figure. Make sure you have completed all the steps during assembly.

8. HOW TO UNFOLD AND FOLD THE SCOOTER

1
2
EN
90º
Oriented the
handlebar in the
same position as the
front wheel, tighten
the screws
Install the levers by
screwing the grips in the
same direction; towards
the body of the scooter
rider
To fold or unfold the scooter, you
must follow the steps below:
First, move the lengthened red
1
piece upwards to unlock it.
Then, press the red button which
2
is located immediately below
the red lengthened part and the
scooter will fold or unfold.
17