Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
A flat or deflated tire results in higher battery consumption in addition to not reaching
the maximun speed.
This scooter incorporates a braking system with wearing parts; monitor their condition
and if necessary, visit an official center for replacement.
Check for loose screws on the scooter. If any are loose, tighten them.
Keep the rear brake disc clean to avoid breakage.
Warning: Do not use alcohol, gasoline, kerosene, volatine chemical sol-
vents or other corrosive solutions to cleam the scooter. Otherwise, you will
cause serious damage to the structure and/or internal elements.
4. BATTERY CHARGING AND MAINTENANCE
We recommend that you fully charge the battery before using your electric scooter for
the first time. The scooter must be turned off to charge the battery. Connect the charger
to your electric scooter through the connector on the left side of the base. Then plug the
charger into the power supply. The battery display will indicate the charge level.
The battery charging time depends on the amperage that each battery has, and can
take up to 5 hours.
When the battery is inactive for a long time, charge it at least once a month. The equip-
ment is fully charged when the red light turns green.
Note: Damage to the battery due to ingress of water, collision and other
abnormal factors is not covered by the warranty.
The charger is provided with a charge protection function, so that charging will stop
automatically when the battery is fully charged to 100%.
Connect the charger to the power supply socket. (AC100V-240V). Do not use batteries of
other brands to avoid damage.
Do not open or disassemble the battery to avoid electric shock. Avoid contact with metal
objects to prevent a short circuit from occurring. Otherwise, the battery may malfunction
or it may harm the user.
It is recommended to use an AC adapter, which comes in the original configuration of
the device, to prevent an accident or vehicle fire from occurring.
After each use of the device, charge the battery to extend its life.
Avoid a complete discharge of the device as it will reduce the life of the battery. When
you use the device at normal room temperature, the battery will travel a much greater
distance and its performance will be better, but if you use the scooter at temperatures
below 0 degrees, the performance and permeability of the vehicle will decrease.
14
Nota: a fully charged scooter runs between 120-180 days of standby time. The
battery has a smart chip, which stores information about its charge-discharge.
If you are not going to charge the battery for a long time, it may cause serious
damage, making it impossible to recharge the device. This type of damage is
not included in the free warranty service. (Caution: Do not disassemble the de-
vice by unauthorized persons, as there is a risk of electric shock or serious injury
as a result of a short circuit).
5. E-SCOOTER COMPONENTS
Accelerator
Reflective
Front light
Creased
Shock absorber
Anti-puncture
wheels 8''
EN
Display
Electric brake
Back brake
Brake light
Power charging port
15
Tabla de contenido
