Cleaning Side Brushes - Shark AI360 ROBOT Manual De Instrucciones

MAINTENANCE
CLEANING AND REPLACING ROBOT'S FILTER
For best results, regularly clean and replace the filter in the robot. See sharkclean.eu for replacement filters.
IMPORTANT: DO NOT use water to clean the robot filter.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove debris every time
you empty the dust bin.
NOTE: Make sure to insert the dust bin completely, until it clicks into place.
sha rkcl e a n.eu
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the base.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.

CLEANING SIDE BRUSHES

CLEAN SIDE BRUSHES AS NEEDED.
Cloth not included.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
s ha rkc lea n.eu