Adler europe AD 2836 Manual De Uso página 4

immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the unit attached to the wall outlet or power supply unit unattended.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The device is designed only for cutting natural human hair.
24. The cutting blades are very sharp. Be careful during assembly, disassembly and
cleaning. Do not touch the blades moving parts during operation!
25. Do not wash the blades in water.
26. Change the attachments only when the unit is turned off.
27. Use only original accessories.
28. To remove hair from inside the machine, use only the included brush.
29. Do not use the device in the bath.
30. Do not use the device on people who are sleeping.
31. During operation, do not place the device on wet surfaces or clothes.
32. The device is not designed to work with external schedulers or separate remote control
system.
DESCRIPTION OF THE DEVICE
1. Power switch 2. Clipping head
attachments (1.5mm, 3mm, 4.5mm, 6mm.)
8. Cleaning brush
BATTERY CHARGING
Before use, charge the battery. To begin charging, connect the power cord (9) to the devices Charging port and the USB cableto the
charger or other USB compatible device. Is using the charger plug it into an 5V 1A mains outlet. The charging icon will light up . A fully
charged battery is sufficient for up to 240 minutes of continuous operation. After charging, remove the charger from the power source.
When the device is not used for a long time please recharge. Recharge it at least once every 6 months to maintain adequate battery
capacity.
USING THE DEVICE
Depending on the needs install the appropriate trimmer attachment as shown in Figure B. To remove it follow the Figure B in reverse
order.
Blade removal:
Using a Philips screwdriver (cross shaped) unscrew the 2 screws from the blade as shown on picture D. Take a new blade and place it in
the same position as the previous blade. Making sure the holes and inside parts are correctly assembled screw the blade into place using
the same screws. Turn on the device to check if the blade is working correctly before use. Please check if the blades are parallel to each
other.
CLEANING
Disconnect the device from the power supply. Remove the attachment from the head. Clear the blades with the supplied brush. After
cleaning, there should be no hair between the blades. After every few haircuts, oil the cutting head pouring 2 to 3 drops of the supplied oil
into the space between the fixed blade and the movable blade. Install the Protection Cover (6). Clean the housing with a dry or slightly
damp cloth.
TECHNICAL DATA
Power supply: 5V 1A
3.. Power / Charging light
6. Protection cover
9. USB cable.
4
5. Cutting length
7. Oil
10. Charging port