Unpacking Instruction; Power Supply; Control Elements - Vonyx STM-3007 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the product be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

CONTROL ELEMENTS

1. MIC MID
This knob adjusts the middle tone of the microphone.
2. MIC TREBLE
This knob adjusts the high tone of the microphone.
3. MIC INPUT JACK
Connect your MIC at this location.
4. KILL FOR TREBLE
Press it to kill microphone treble volume (including indicator light).
5. KILL FOR MID
Press it to kill microphone middle volume (including indicator light).
6. EQUALIZER
Allows you to tailor the mixer output to suit be cut or boost by up to 10dB.
7. CHANNEL GAIN
This rotary control adjusts the input level.
8. CHANNEL CUE
Use it to monitor the selected audio input source.
9. CHANNEL INPUT SELECTOR
Lets you to choose the input source to play for each channel.
10. CHANNEL LEVEOL CONTROL
Lets you control mixer's overall channel volume level.
11. DISPLAY METER
Indicates the levels of left and right master channels.
12. MASTER MONO/STEREO SELECTOR
Select mono mode or stereo mode.
4