Unpacking Instruction; Power Supply; Front Panel - Vonyx VMM201 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.

FRONT PANEL

1. MIC/LINE & GUITAR INPUT
Combo input jack for mono signal (XLR microphones or
1/4" line input devices) or instruments such as an
electric guitar.
2. HI-Z
Switch to choose different input sources. Press to
connect with a high impedance audio source. When de-
pressed, XLR-microphone or low impedance audio
device input is selected.
3. LINE IN VOLUME CONTROL
Turn to adjust the RCA line input (13) volume.
4. CHANNEL 1 VOLUME CONTROL
Turn to adjust the volume for channel 1 (1). The led-
indicator lights up when the input signal is too high.
5. PHANTOM SWITCH
Use to activate phantom power supply on the XLR
connector (+48V phantom power).
6. INPUT SELECTOR SWITCH
Change the input signal between LINE IN and USB/BT.
7. MAIN VOLUME CONTROL
Turn to adjust the volume of the MAIN- (12) and USB
channel (14). The led-indicator lights up when the input
signal is too high.
8. POWER LED
Lights up when the power is turned on.
9. HEADPHONES VOLUME CONTROL
Turn to adjust the volume of the headphones channel.
10. HEADPHONES OUTPUT
3.5mm stereo jack output for connecting headphones.
11. BT/USB SELECTOR
Change between BT and USB input.
12. STEREO RCA OUTPUT (MAIN MIX)
Stereo RCA output jacks. Connect with the input of an
amplifier or a recorder.
13. STEREO RCA LINE INPUT
Stereo RCA input jacks. Connect with the output of an audio source with line signal, such as a CD player, tape deck, etc.
4