Xylem FLOJET 5000 Serie Manual Del Usuario página 2

Figure 1
A
A. Main pump module with On/Off rocker switch
B. Suction Wand with Universal Cap Seal,
Float Switch and Hose Assembly
C. 20 ft (6.1m) of 1/4 in. (6.35mm) OD. Discharge Tube
D. Outlet port fitting kit
E. Universal wall power transformer and adapters
Wall Power
Transformer
On/Off Switch
Push clip up
to lock
Insert float sensor switch plug/connector into
pump module "SWITCH" port.
The connections for the float and power
supply will require moderate force to insert
fully. This is a design feature that assures the
connections are held securely after initial
installation. MAKE SURE PLUG / CONNECTOR
IS INSERTED ALL THE WAY INTO THE
CONNECTIONS. FAILURE TO INSERT FULLY WILL
LEAD TO POOR OPERATION OR NO OPERATION.
Grounded Outlet
To change transformer adapter plug:
1. Push and hold tab
2. Slide plug off
3. Slide new plug on until it locks
The BWS 5000 is only to be used
with the power transformer and
adapters provided
Power Cord
To install tube into "OUT" port.
Push 1/4" discharge tubing all
the way into quick connect port
(as far as it will go).
Insert DC plug/connector into
pump module "DC IN" port.
The connections for the float and power
supply will require moderate force to
insert fully. This is a design feature
that assures the connections are held
securely after initial installation. MAKE
SURE PLUG / CONNECTOR IS INSERTED
ALL THE WAY INTO THE CONNECTIONS.
FAILURE TO INSERT FULLY WILL LEAD TO
POOR OPERATION OR NO OPERATION.
Insert suction hose port fitting into
pump module "IN" port and slide
locking port clip in place.
2
C
E
B
D