Infiniton WFL-204 Manual De Instrucciones página 78

Top zone: 5- 12 ˚C
Bottom zone: 12-18 ˚C
Increase temperature
K4: Press the button once, the LED display will flash indicating the current temperature. Press
again to set the temperature. 1 touch will increase the temperature by 1 degree. The blink
stops after 5 seconds without action on your part, and the new temperature requested is
recorded. The LED display then shows the actual temperature inside.
Decrease temperature
K5: Press the button once, the LED display will flash indicating the current temperature. Press
again to set the temperature. 1 touch will reduce the temperature by 1 degree. The blink
stops after 5 seconds without action on your part, and the newly set temperature is recorded.
The LED display then shows the actual inside temperature.
Settings
Fahrenheit/Celsius
K6: Switch the temperature display between Fahrenheit/Celsius by pressing the button.
There are two internal fans for airflow however fluctuations of up to 3 degrees is expected.
The average temperature throughout the wine cellar will be a maximum of 1.5˚C of the
requested temperature (once sufficient time for cooling has passed). Once a temperature
difference of 3˚C above the set temperature is detected, the cooling cycle will start to bring
the temperature down to below the set temperature. Once the cooler temperature is
reached, the cooling stops and the temperature inside the wine cellar is allowed to slowly
increase. This cycle is continuous and results in a very small range of constant fluctuation.
23