monzana MZPP28 Manual De Instrucciones página 15

PARTS LIST (graphic on page 2)
Base for filter tank
Drainage nozzle
Lateral filter screen
Centre tube
Venting unit
Filter tank
Flange clamp
O-ring
PLACEMENT OF THE UNIT
Place the sand filter system (empty of sand) close to the pool. Important: the system must be
located far enough from the pool so that splash water cannot damage the pump or cause
flooding.
The system must also be placed on a secure, stable surface. The filled tank will be very heavy and
must not tip over, e.g. due to collapsing ground, nor cause any damage to your floor.
Take into account the connections to be made later, e.g. water and pump power, when positioning
the filter.
Ensure that the instruction label is still visible on the tank and pump in case any questions or issues
arise later.
Instructions
• Ensure that the filter works under pressure and that the pump can provide sufficient power.
• If the pump is placed above the water level, a backflow valve must be installed in the system
(please refer to the instructions for the pump in question).
• If the pump is positioned below the water level, it is important for maintenance purposes to
ensure that the water supply to the pump is interrupted, otherwise the water may run out of
the pool unhindered.
• Hoses and connections should be kept as short as possible and without any kinks. This reduces
the flow capacity, meaning your system would suffer unnecessary loss of performance.
• Make sure that the connection rings, hose clamps and all sealing rings are properly positioned.
• Never over-tighten the screws of the hose clamps and the neck of the tank. This would damage
them and cause the system to lose pressure.
CONSTRUCTION (graphic on page 3)
1. Secure the pump (12) to the base plate (14) using the screws (13).
2. Mount the drainage nozzle (2) on the filter tank (6) as shown, making sure that the seals are
in the correct position.
3. Insert the lateral filter screen (3) into the centre tube (4). These elements must be assembled
in the filter tank (6). To do this, turn the filter screen (3) 90° clockwise. The filter screen (3) is
securely installed when you hear a 'click'. Check that the vent hose (5) is securely attached to
the centre tube (4) and that the other end of the vent hose (5) is above the maximum fill
level. DO NOT embed the vent hose (5) in the sand.
NO. STK
1 1
2 1
3 8
4 1
5 1
6 1
7 1
8 1
15
6-way valve
Connector
PVC hose
0.75 HP pump
(220 – 240 V~50/60 Hz)
M8 x 35 screw and M8 nut 13
Base plate
ST4.8 x 20 screw
NO. STK
9 1
10 1
11 1
12 1
4
14 1
15 4
www.DEUBAXXL.de