Maintenance; Draining The Appliance; Clean The Strainer; Specification - Stiebel Eltron UltraHot Plus Instrucciones De Funcionamiento E Instalación

INSTALLATION

Maintenance

16. Maintenance
WARNING Electrocution
Completely disconnect the appliance from the power
supply when performing any work on it.
Uninstall the appliance when performing maintenance.

16.1 Draining the appliance

WARNING Burns
Hot water may escape when draining.
Before you drain the appliance, unplug the power plug and
flush for at least two minutes until only cold water is coming
out of the hot water outlet of the faucet.
Drain the appliance via the connectors.

16.2 Clean the strainer

1 Disconnect the push-fit connector
2 Remove the strainer
www.stiebel-eltron-usa.com
Remove the cold water supply connection.
Disconnect the push-fit connector from the appliance.
Using pliers, pull the strainer out of the cold water supply
connection.
Descale or replace the strainer.
Reinstall the strainer, reinstall the push-fit connector, and
reconnect the cold water supply.
17. Specification

17.1 Dimensions and connections

c08
4 (101)
c01
2 (61)
i13
i13
3 /
9
16
(90)
7 (200)
c01 Cold water supply
c06 Hot water outlet
i13 Wall mounting bracket
17.2 Country-specific approvals and certifications
See the type plate for certifications.

17.3 Extreme operating and fault conditions

If the appliance fails, temperatures of up to 212 °F (100 °C) may
occur briefly in the installation.
UltraHot Plus
2 (61)
UltraHot Plus/Premium
Connectors
Nozzle
& UltraHot Premium
™ ™
| 13