Powering The Laser - DeWalt DCLE34220 Manual De Instrucciones

• Do not dispose of batteries in fire.
E
• Keep batteries out of reach of children.
• Remove batteries when the device is not in use.
• Use only the charger specified for your rechargeable
battery pack.
• Disconnect the battery pack from the laser before
making any adjustments, changing accessories, or
storing the laser. Such preventative safety measures
reduce the risk of starting the laser accidentally.
• Use the laser only with specifically designated
battery packs. Use of other battery packs may create
a risk of injury and fire.
• Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
• Do not use a battery pack or laser that is damaged or
modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion, or
risk of injury.
• Do not expose a battery pack or laser to fire
or excessive temperature. Exposure to fire or
temperature above 265 °F (130 °C) may cause
an explosion.
• Follow all the charging instructions and do not charge
the battery pack outside of the temperature range
specified in the instructions. Charging improperly or
at temperatures outside of the specified range may
damage the battery and increase the risk of fire.

Powering the Laser

This laser can be powered by either of these
battery packs:
• A D WALT 12V MAX* Li-ion Battery Pack.
e
*Maximum initial battery voltage (measured without a
workload) is 12 volts. Nominal voltage is 10.8.
16
• A D WALT 20V MAX* Li-ion Battery Pack.
e
*Maximum initial battery voltage (measured without a
workload) is 20 volts. Nominal voltage is 18.
Battery Type
12V
DCB120, DCB122, DCB124,
DCB127
20V DCB201, DCB203, DCB203BT,
DCB204, DCB204BT, DCB205,
DCB205BT, DCB206, DCB207,
DCB208, DCB230, DCB240
Use of any other batteries may create a risk of fire.
Charging the Li-ion Battery
If the D WALT 12V/20V MAX* Li-ion battery pack is
1.
e
attached to the laser, remove it.
• While pressing down on the release button on the
battery pack (Figure
B 1
up to unlock it from the laser.
• Pull the battery pack the rest of the way up and
out of the laser (Figure
Plug the charger cord into an electrical outlet.
2.
Slide the battery pack into the charger until it snaps
3.
in place (Figure ). On the charger, the left
A 1
indicator light will flash to let you know the battery is
being charged.
After the battery is fully-charged (the indicator light
4.
on the charger no longer flashes), press and hold
the release button on the battery pack
(Figure ) and slide the pack out of the charger
A 2
(Figure ).
A 3
Slide the battery pack down in the laser until it
5.
snaps in place (Figure
A 4
Battery Pack
), pull the battery pack
).
B 2
).