Use The Spray Gun; Change The Spray Tip - GreenWorks Pro GPW3001CO Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
The water supply must come from the water main
Do not use hot water
Do not use water from ponds or lakes
WARNING
Always observe all the local regulations when you connect
the garden hose to the water supply. Direct connection
through a receiver tank or backflow preventer is usually
permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
If the filter is damaged, do not use the machine until the
filter is replaced.
If the filter is dirty, clean the filter.
17
1. Uncoil the garden hose (17).
2. Let the water flow through the garden hose (17) for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (17) to the
water inlet (8) connector.
CAUTION
There must be a minimum of 10 feet of free hose between
the water inlet and the water supply.
English
8
4.2

USE THE SPRAY GUN

21
22
WARNING
For safe control, keep your hands on the spray gun at all
times.
Pull and hold the spray gun trigger (21) to start the
machine.
Release the spray gun trigger (21) to stop water flow
through the spray tip.
4.2.1
UNLOCK THE SPRAY GUN TRIGGER
Push the trigger safety lock-out (21) down until it clicks
into the slot.
4.2.2
LOCK THE SPRAY GUN TRIGGER
Push the trigger safety lock-out (21) up and into it's
original position.
4.3

CHANGE THE SPRAY TIP

18
Click
WARNING
Before you change the spray tip:
1. Pull the spray gun trigger to release water pressure.
2. Engage the trigger safety lock-out on the spray gun.
3. Stop the machine.
9
19
EN
Tabla de contenido
loading

Este manual también es adecuado para:

Pwa211

Tabla de contenido