Instructions For Installation - FONRI GS558D-H04 Guia Del Usuario

Instructions for Installation

Insert two AA batteries into the smoke sensor's battery compartment.
Turn on the sensor by following the instructions in the "Wireless Connection" section.
Make sure the wireless network connection is good.
To install the mounting bracket to the ceiling, hold the bracket against the ceiling and
use pencil to mark where the mounting holes will be.
Drill two holes at the marked locations with diameter around 5mm. Insert the two plastic
dowels into the holes with the hammer.
Attach the mounting bracket to the plastic dowels and tighten the screws (3*25mm).
See FIGURE-3..
Test the sensor using the test button. The alarm will sound 3 short beeps, then pause for
1.5 seconds and continue this pattern until you release the button.
If there is no sound, it means your alarm is faulty. You can refer to the "Troubleshooting"
section or return the device to the point of sale within the period of warranty.
You can contact the sales point for any questions about installation.
Other smoke sensors may also alarm during testing. They will also turn off within 1 min-
ute of releasing the test button. So you can control the wireless access function.
WARNING:
To avoid any injury, the sensor should be securely installed on the ceiling, following the
instructions.
13