Configuration Options - Bellman & Symfon BE2020 Manual De Instrucciones

Configuration options

This device can be configured with the following Bellman & Symfon original accessories:
BE9136 External microphone

 BE9159 Neck loop with 90 cm (3") cable
 BE9161 Neck loop with 15 cm (6") cable
BE9126 Cable kit with 5 m, 16.4 ft.

For detailed product information, see the corresponding user manual.
Operating conditions
Operate the device in a dry environment within the temperature and humidity limits stated in this
leaflet. If the device gets wet or is exposed to moisture, it should no longer be regarded as reliable
and should therefore be replaced.
Cleaning
Disconnect all cables before you clean your device. Use a soft, lint-free cloth. Avoid getting moisture
in openings. Do not use household cleaners, aerosol sprays, solvents, alcohol, ammonia or abrasives.
This device does not require sterilization.
Service and support
If the device appears to be damaged or doesn't function properly, follow the instructions in the
user guide. If the product still doesn't function as intended, contact your local Bellman & Symfon
representative for information on service and warranty.
Warranty conditions
Bellman & Symfon guarantees this product for two (2) years from date of purchase against any
defects that are due to faulty materials or workmanship.
This guarantee only applies to normal conditions of use and service, and does not include damage
resulting from accident, neglect, misuse, unauthorized dismantling, or contamination howsoever
caused. This guarantee excludes incidental and consequential damage. Furthermore, the warranty
does not cover Acts of God, such as fire, flood, hurricanes and tornadoes.
This warranty gives you specific legal rights and you may also have other rights that vary with
territory. Some countries or jurisdictions do not allow the limitation or exclusion of incidental or con-
sequential damages, or limitations on how long an implied warranty lasts, so the above limitation
may not apply to you. This guarantee is in addition to your statutory rights as a consumer. The above
warranty may not be altered except in writing signed by both parties hereto.
Compliance information
Hereby Bellman & Symfon declares that, in Europe, this product is in compliance with the essential
requirements of the Medical Device Regulation EU 2017/745 as well as the directives and regulations
listed below. The full text of the declaration of conformity can be obtained from Bellman & Symfon
or your local Bellman & Symfon representative. Visit
 Medical Device Regulation (MDR)
EC General Product Safety Directive

 EC Battery Directive
REACH Regulation

Restriction of Hazardous Substances Directive (RoHS)

 Waste Electrical & Electronic Equipment (WEEE)
Electromagnetic Compatibility Directive (EMC)

24
BE9122 Headphones

 BE9124 In-ear earphones
 BE9147 Travel case
BE9408 External cable

bellman.com for contact information.
Regulatory symbols
With this symbol, Bellman & Symfon confirms that the product meets the Medical Device
Regulation EU 2017/745.
This symbol indicates the manufacturer's serial number so that a specific medical device
can be identified. It's available on the product and gift box.
This symbol indicates the manufacturer's catalogue number so that the medical device can
be identified. It's available on the product and gift box.
This symbol indicates the medical device manufacturer, as defined in EU Directives 90/385/
EEC, 93/42/EEC and 98/79/EC.
This symbol indicates that the user should consult the instructions for use.
This symbol indicates that it is important for the user to pay attention to the relevant
warning notices in the instructions for use.
This symbol indicates important information for handling and product safety.
Temperature during transport and storage: –10° to 50° C, 14° to 122° F
Temperature during operation: 0° to 35° C, 32° to 95° F
Humidity during transportation and storage: <90%, non-condensing
Humidity during operation: 15% to 90%, non-condensing
Atmospheric pressure during operation, transportation and storage:
700hpa to 1060hpa
This device is designed such that it functions without problems or restrictions if used as
Operating
conditions intended, unless otherwise noted in this booklet.
With this CE symbol, Bellman & Symfon confirms that the product meets EU standards
for health, safety, and environmental protection as well as the Radio Equipment Directive
2014/53/EU.
This symbol indicates that the product shall not be treated as household waste. Please
hand over your old or unused product to the applicable collection point for the recycling of
electrical and electronic equipment.
ISO Certification of legal manufacturer
Bellman & Symfon is certified in accordance with SS-EN ISO 9001 and SS-EN ISO 13485.
SS-EN ISO 9001 Certification Number: CN19/42071
SS-EN ISO 13485 Certification Number: CN19/42070
Certification Body
SGS United Kingdom Ltd
Inward Way
Rossmore Business Park Ellesmere Port Cheshire CH65 3EN UK
EN
25