General Warnings - Bellman & Symfon BE2020 Manual De Instrucciones

Connecting
Maxi to the TV
The easiest way to connect Maxi to your TV is
using the BE9126 Cable kit accessory.
Here is how you set it up:
1 Connect one end of the mini-stereo cable to
the Maxi audio input (1).
2
Connect the other end to the RCA adapter
(13).
3 Connect the RCA plugs (14) to the RCA
audio output on your TV.
Mini-stereo cable
Attaching
the clip
To attach the clip, place the
clip against the back cover
and press firmly until it
locks. To remove it, gently
pull the round handles out
from the sides.
22
You can also connect the mini-stereo cable
directly to the headphones output on your TV.
Please note that this may mute the speakers
on some TV models.
Using the same method, you can connect Maxi
to your radio, computer or mobile phone.
In case your TV does not have any audio
outputs, the external microphone can also be
used for listening to the TV. Just attach or place
the microphone close to the TV's loudspeaker
and connect it to the Maxi audio input (1).
RCA Audio output
RCA adapter
Television

General warnings

This section contains important information about safety, handling and operating conditions.
Keep this leaflet for future use. If you are just installing the device, this leaflet must be given to the
householder.
Hazard warnings
 Failure to follow these safety instructions
could result in fire, electric shock, or other
injury or damage to the device or other
property.
Keep this device out of reach of children

under 3 years.
 Do not use or store this device near any heat
sources such as naked flames, radiators,
ovens or other devices that produce heat.
 Protect cables from any potential source of
damage.
Use only battery types specified in this

leaflet. Do not expose batteries to fire or to
direct sunlight.
 Use of this equipment adjacent to or stacked
with other equipment should be avoided
because it could result in improper oper-
ation. If such use is necessary, this equip-
ment and the other equipment should be
observed to verify that they are operating
 Do not dismantle the device; there is a risk
of electric shock. Tampering with, modifying
or dismantling the device will void warranty.
normally.
Use of accessories, transducers and cables

other than those specified or provided
Information on product safety
 Failure to follow these instructions could
result in damage to the device and void the
warranty.
Do not drop your device. Dropping onto a

hard surface can damage it.
 Do not use the device in areas where elec-
tronic equipment is prohibited.
If a serious incident occurs in relation to

this device, contact the manufacturer and
relevant authority.
by the manufacturer of this equipment
could result in increased electromagnetic
emissions or decreased electromagnetic
immunity of this equipment and result in
improper operation.
 Portable RF communications equipment
(including peripherals such as antenna
cables and external antennas) should be
used no closer than 30 cm,12" to any part of
this device, including cables specified by the
manufacturer. Otherwise, degradation of the
performance of this equipment could result.
This device has a very powerful amplifier

and the sound level can cause discomfort
or, in serious cases, endanger hearing if the
product is used carelessly. Always turn the
volume down to a low level before putting
on the headphones!
This device is designed for indoor use only.

Do not expose the device to moisture.
 Protect the device from shocks during stor-
age and transport.
Batteries are toxic. Do not swallow them!

Keep out of reach of children and pets. If
they are swallowed, consult your physician
immediately!
 If you encounter other problems with your
device, contact the point of purchase,
your local Bellman & Symfon office or the
manufacturer. Visit bellman.com for contact
information.
The device may only be repaired by an

authorized service center.
 This device should not be used on aircrafts
unless specifically permitted by flight per-
sonnel.
EN
23