Software Version; System Reset - Sangean DPR-99+ Manual De Instrucciones

Software version

The software display cannot be altered and is just for your reference.
1. To view the software version on the display press and hold in the
Info/Menu button for two seconds.
2. Press the Tuning Up/Down buttons until the display shows "SW
version" on the lower line . Press the Select button to enter the SW
version. The version number is then shown on the lower line of the
display. Press and release the Info button will revert to normal tuning
mode.

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and hold down the Info/Menu button for 2 seconds.
2. Press the Tuning Up or Down buttons until the display shows "Factory
reset" on the lower line then press and release the Select button to
select System reset.
3. Press the Select button once more and a full reset will be performed.
All presets and station lists will be erased.
4. After a system reset a scan of the DAB band will be performed. In
case of malfunction due to electrostatic discharge, reset the product
(reconnection of power source may be required) to resume normal
operation.
GB
18