Honeywell Home R200ST-N1 Guía De Instalación Y Usuario página 6

1. Introduction
Thank you for purchasing Resideo R200ST-N1 interconnected fire alarm, equipped with both smoke and heat
sensors. This product is suitable for indoor installation in domestic premises, including static holiday homes and
caravans.
This manual contains important safety information about the installation and operation of the alarm. Please read
the manual carefully and keep it in a safe place for future reference.
2. Where to install the device?
(see page 2)
Refer to page 2 for guidance. Please ensure that you also follow country-specific regulations and guidelines, such
as: British BS5839-6 or German DIN14676. If in doubt, please check, for example by contacting your local Fire
Service.
3. Where not to install the device
 In an environment with a risk of draught (e.g. close to air conditioning, fans, ventilation outlets).
 In areas where steam or fumes are emitted, e.g. kitchens: use R200H-N1 (alarm with heat sensor) instead.
NOTE: To avoid sensor contamination, the smoke alarm should be removed from the mounting for the duration of
any building work involving dust or debris. If this is not possible, the alarm vents must be fully covered with a
brightly coloured plastic bag or tape to reduce the risk of leaving covered when works are completed. When
covered, the alarm will not detect fires or smoke, so remove the covering when the work is completed each day
and replace it the following day if necessary.
4. Installation
(see page 3-4)
Refer to pages 3 and 4 for guidance.
WARNING: The alarm contains a permanently sealed, non-replaceable battery, and does not contain serviceable
parts inside. Any attempt to open or repair it creates a risk of electric shock or malfunction.
5. Activation
(see page 4)
Before commissioning the smoke alarm, it is important to activate and test it for correct operation:
 If you need to enable the tamper proof locking feature, break off or cut off the small cylinder ①.
 Install the alarm in its mounting bracket ② and twist until it clicks ③. The LED indicators will flash once and
emit a beep.
 The entire surface of the alarm cover is the test/silence button. Press it firmly for at least 3 seconds ④. The
alarm will emit 3 short beeps with LED flash at the same pace.

Release the button. The alarm may beep for a few more seconds, to confirming it's been activated.
6. Removal
(see page 4)
-6-