Connection To The Power Supply; Installation Diagram - Franke FH 604-1E 4I T PWL Instrucciones Para El Uso E Instalacion

CONNECTION TO THE POWER SUPPLY

Basic adjustment of sensors
to the ambience

Installation diagram

TECNICAL INFORMATION
Type
Width
Electrical connection
Type of switch
Cooking zones (Ø, mm/W)
Forward left
Rear left
Rear right
Forward right
Total power (W)
P= extra powerful setting
All manuals and user guides at all-guides.com
• Connections may be carried out by a qualified technician only. The earthing protection
must comply with the standing regulations.
• Connection terminals are revealed when the connection box cover is removed.
• Prior any attempted connection check that the voltage indicated on the rating plate is in
line with your home power supply.
• The rating plate is located underneath the appliance.
• The appliance is manufactured for use with the power supply voltage 230-240 V ~.
• In order to make a fixed connection to the mains, insert an all-pole circuit breaker
between the appliance and the mains. This device shall have a contact separation in all
poles, providing full disconnection under overvoltage category III conditions.
• The connection should be selected in accordance with the declared charge capacity of
the mains and the fuse power.
• Such appliances are allowed to be mounted on one side next to a high kitchen cabinet,
the height of which may exceed that of the appliance. On the opposite side however,
only a kitchen cabinet of equal height as the appliance is allowed.
• Upon the completion of installation, live wires and isolated cables must be adequately
protected against accidental touching.
Upon each connection to the power supply the sensors of the appliance are automatically
adjusted to the environment to ensure their proper function. All displays turn on and are
fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise the
adjustment procedure will be interrupted until such objects are removed from the sensor
surface. During this period the regulation of the cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance, disconnect the power supply. In
accordance with the mains voltage the appliance should be connected in line with the
attached diagram.
The earthing wire (PE) must be connected to the terminal marked with the earthing
symbol.
The connection cable must lead through the relief safety device, protecting it from
accidental pulling out. Upon the completion of installation switch all the hotplates on for
about 3 minutes to check the proper functioning.
Connection must be carried out by means of harmonized cables as H05V2V2-F (90°C), or
with equal or better features.
FH 604-1E 4I T PWL
230-240 V~ or 400-415 V 2N~, 50/60 Hz
19
FH 604-1 4I T PWL
580 mm
Electronic sensors
210, 1500 (P=2000)
145, 1200 (P=1600)
210, 1500 (P=2000)
145, 1200 (P=1600)
2800