Ec Declaration Of Conformity - COMAC cm mini orbital Manual De Uso Y Mantenimiento

To dispose of the appliance, take it to a demolition centre or an authorised collection centre.
Before scrapping the appliance, it is necessary to remove and separate out the following materials,
then send them to the appropriate collection centres in accordance with applicable environmental
hygiene regulations:
• Pad holders or brushes
• Electric and electronic parts*
• Plastic parts
• Metallic parts
(*) In particular, contact your distributor when scrapping electric and electronic parts.
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance centre.
PROBLEM POSSIBLE CAUSE
The power cable extension
is not connected to the mains
socket.
The power cable extension
is not
appliance's power cable.
The electrical specifications
of the
THE APPLIANCE DOES NOT correspond to the electrical
SWITCH ON specifications of the power
supply network.
Extension cable damaged.
Overheating of the brush head
motor.

EC DECLARATION OF CONFORMITY

declares under its sole responsibility that the products
MACHINE:SINGLE DISC mod.CM ORBITAL MINI 230V
comply with the requirements of the following Directives:
• 2006/42/CE: Direttiva macchine.
• 2014/35/CE: Direttiva bassa tensione.
• 2014/30/CE: Direttiva compatibilità elettromagnetica.
• 2011/65/UE : RoHS
The person authorized to compile the technical file:
Sig. Giancarlo Ruffo
Via Maestri del Lavoro, 13
37059 Santa Maria di Zevio (VR) Italy
PRODUCTION YEAR 2021
DISPOSAL
TROUBLESHOOTING
Check that the plug on the extension cable has been inserted into the
mains supply socket.
Check that the plug on the cable of the appliance has been inserted into
connected to the
the socket on the extension cable.
appliance should Make sure that the electrical specifications of the appliance correspond
to the electrical specifications of the power supply network, check the
technical information on the serial number plate.
Check the extension cable is not damaged, and if it is, replace it.
Make sure that the thermal breaker on the back of the handlebar has
not tripped. If it has, wait a few minutes until it has cooled down, then
press the specific circuit breaker button to reactivate the power supply
and motor operation
La sottoscritta ditta fabbricante:
COMAC S.p.a.
Via Maestri del Lavoro, 13
37059 Santa Maria di Zevio (VR) Italy
18
SOLUTION
COMAC S.p.a.
Legal representative
Giancarlo Ruffo