Spark Plug; Air Filter - Goodyear GY 46LM Manual De Instrucciones

English • Owner´s manual
Change of leaves
To replace the blade, unscrew and remove the blade screw. Empty
the oil tank before removing the blade.
- Reinsert it as illustrated.
- Tighten the screw properly.
- Tighten with a torque of 45 Nm.
- When changing the blade, also change the blade screw.
Oil change
1. Let the engine slow down and wait until the engine stops and cool
slightly.
2. Disconnect the spark plug wire and keep it away from the spark
plug cap.
3. When the engine is still warm, remove the oil plug (A) and pour the
oil into a container.
4. Clean the oil plug before replacing it.
5. Set up. Remove the oil spindle. Add 0.3L of the recommended oil
slowly to the upper end of the dipstick. Do not exceed the limit.
6. Replace the stem
NOTICE! Avoid contact with skin with waste oil. Wash skin with
soap and water after each oil change.
CAUTION: Used oil is a hazardous product. It is recommended to take it to the recycling point inside a sealed
container. Do not throw away with the spill of your house.

Spark plug

Once the engine has cooled, remove the spark
that the distance between the electrodes is
ning.

Air filter

Remove the air filter cover that is held by
the air intake, replace the air filter and replace the cap.
Running out of fuel tank and carburetor
1. Place a suitable container under the carburetor and use a funnel to prevent spilling.
2. Remove the drain bolt and turn the faucet to the ON position.
26
plug
0.75 mm
some
clips and remove the sponge filter. To prevent something from entering
Sponge filter
Paper filter
Filter cover
and wipe the electrode with a wire brush. Use
(0.030 "). Replace the spark plug carefully to avoid overtighte-
A
an indicator
so