Maintenance; Troubleshooting - Truper ASP-04 Manual

Maintenance

Cleansing and care
• Always keep the vents clean and free of obstructions to
ensure proper engine cooling.
• Regularly inspect all mounting screws and make sure
they are tightened properly. In case any of the screws is
loose, tighten it immediately
Service
• Tools should only be serviced at a
Authorized Service Center. Service and maintenance by
unqualified persons can be dangerous and may result in
personal injury and void the product warranty.

Troubleshooting

Problem Cause
The vacuum cleaner is • No power.
not working. • Defective cable.
• The container is full.
Dust comes out of the • The filter cartridge is not set
motor cover. or is damaged.
Reduced motor • There is a blockage in the
efficiency and nozzle, hose or container inlet.
vibration / speed. • The filter cartridge is clogged
due to the presence of fine
dust.
Carbon brush replacement
• The carbons should be checked periodically, and always
be replaced by a
Center when they have worn out.
• After they have been replaced, ask to inspect if the new
carbons can move freely in the carbon holder and request
that the tool be turned on for 5 minutes to match the
contact of the carbons and commutator .
• Only genuine
specifically designed with the proper hardness and
electrical resistance for each type of motor, should be
used. Out of specification carbons may damage the motor.
• When changing carbons, always replace both carbons.
Solution
• Check the power supply, cable, circuit switches, fuses.
• Unplug and check the electric cable. If damaged, have it repaired
in a Authorized Service Center.
• Empty the container.
• Set or replace the cartridge filter.
• Check nozzle, hose and container inlet for blockage.
• Remove the filter and clean it or install a new one.
Authorized Service
eplacement carbons,
9
ENGLISH