Bosch GSR18V-1330C Instrucciones De Funcionamiento Y Seguridad página 16

2610056705 GSB18V-1330C 04-21.qxp_GSB18V-1330C GSR18V-1330C 5/3/21 7:00 AM Page 16
Inserting & Releasing Battery Pack
To insert battery pack: Set Forward/
Reversing lever to the center (off position).
Slide charged battery pack (12) into the
housing until the battery pack locks into
position (Fig. 12).
To check if the battery is locked in place,
lightly pull the battery in the opposite
direction. If the battery moves, do not use
the tool and repeat the insertion procedure
until the battery is locked in place and does
not slide backwards.
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
To remove battery pack: press the battery
pack release button (13) and slide the
battery pack towards the front of the tool.
Press the battery pack release button again
and slide the battery pack completely out
of tool housing (Fig. 13).
Depth Gauge
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle is
installed, make sure the drill bit has been
fully inserted into the chuck before setting
the depth gauge.
To adjust depth: turn the wing nut counter-
clockwise to loosen depth gauge, slide depth
gauge to desired depth X, and securely
tighten wing nut clockwise (Fig. 14).
Temperature Overload Protection
Avoid using battery operated tools
continuously, for long periods of time,
while subjecting the tool to overload
conditions, such as drilling with large
diameter accessories into hard materials.
Using battery powered tools at extreme
loads, may cause the battery to exceed its
allowable operating temperature range.
When the battery exceeds normal operating
temperature caused by overload, the speed
of the tool may be reduced and the tool
may appear to lose power. To regain the
tool's full performance, the battery must be
allowed to cool, until the operating
temperature returns to normal.
Operating Instructions
FIG. 12
FIG. 13
16
(12)
(13)
WING
NUT
DEPTH
G UGE
X
DRILL BIT
FIG. 14