Working With The Unit - Steinberg Systems SBS-MD-24 Manual De Instrucciones

CONNECTING HEADPHONES
1. Choosing headphones with volume control is recommended.
2. Insert the 3.5 mm plug into the headphone socket located at the bottom right
of the control panel. When the headphones are connected, the internal
speaker is disconnected.
3. Adjust the volume.
4. Set the headphones to a low volume, then adjust the volume to the
appropriate level.
CAUTION!
high traffic areas. Pay attention to traffic safety.
3.3.

Working with the unit

MODES OF OPERATION:
The detector has two operating modes: DISC (DISCRIMINATION) and NOTCH (SELECTIVE
DISCRIMINATION, INSERT). Select the mode appropriate to the target you are searching
for:
a) DISC MODE (DISCRIMINATION)
In DISC mode the user can eliminate the detection of unwanted metals. To
eliminate some categories from detection, set the numerical discrimination
value according to the digital object identification (see METAL TABLE) using
the "+", "-" buttons. The detector will find only those metals whose value in
the METAL TABLE is specified as greater than or equal to the numerical
discrimination value.
b) NOTCH MODE (SELECTIVE DISCRIMINATION, INDENTATION):
In NOTCH mode, the user specifies which categories of metals to search for
and which not to search for. Unlike normal discrimination (DISC), NOTCH mode
is capable of detecting iron and coins and rejecting aluminum foil, for example.
TESTING
1. Testing the unit before using it for the first time both indoors and outdoors is
recommended.
2. Note how the detector reacts to individual metals.
3. Prepare the accessories to perform the test:
nail,
•
a silver coin,
•
a gold ring,
•
• zinc coin.
OPERATING THE UNIT INDOORS
Do not wear headphones while operating the locator near