Environmental Protection - Infiniton VT-132M Instrucciones De Instalación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

10) Do not opérate reversing switch while fan blades are in motion. Fan must be turned off and blades
stopped before reversing blade direction.
11) Avoid placing objects in the path of the blades.
12) Always disconnect the appliance before cleaning or doing maintenance. Do not use wáter or de-
tergents when cleaning the fan or fan blades. In order to not damage the product, it is advisable to use
adapted equipment to the fragile surfaces and products slowing the wear on the appliance. A dry dust
cloth or lightly dampened cloth will be suitable for most cleaning.
13) After making electrical connections, spliced conductors should be turned upward and pushed care-
fully up into outlet box. The wires should be spread apart with the grounded conductor and the equip-
ment-grounding conductor on one side of the outlet box.
14) The supplier disclaims all liability for personal injury or property damage arising from incorrect use or
installation of the fan. In doubt, call upon an electrician.
15) Children should be supervised to ensure that they do not play with the appliance.
16) This appliance can be used by children aged from 8 years and above and persons with reduced phy-
sical, sensory or mental capabilities or lack of experience and knowledge if they have been given super-
vision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.

ENVIRONMENTAL PROTECTION:

WARNING!
Electrical products must not be thrown out with domestic waste. They must be taken to a communa
collecting point for environmentally friendly disposal in accordance with local regulations. Contact your
local authorities or stocklist for advice on recycling. The packaging material is recyclable. Dispose of the
packaging in an environmentally friendly manner and make it available for the recyclable material co-
llection-service.
ASSEMBLING AND INSTALLATION:
1) Verify all parts against part list and diagram.
2) Remove motor from packing. To avoid damage to finish assemble motor on soft padded surface or use
the original packaging in motor box.
3) It is essential that the outlet box or structural member from which the far is to be suspended will safely
support the fan. In view of the torque and weight factors involved some outlet boxes will require additio-
nal strengthening by securing more firmly to Wood beams of steel supports.
4) Attach the mounting bracket to the outlet box with the screws provided. Attached canopy into han-
ging bracket with fan unit and ball joint hang below the canopy and secured with 4 setscrews.
5) Making sure the ball is properly seated with molded Groove engaged with the tab on canopy be cer-
tain that hanging ball is fully locked into position.
6) Attach blades to the blade brackets using screws, nuts and washers. The three screws per blade are
protruded from bottom of the blade bracket, through the blade bracket into the blade. Then place the
washer and nut on top of the screw, holding the nut, thread the screw to tighten the blade and the blade
bracket. Repeat instruction for fixing all blades to blade brackets.
7) Secure the blades to the fan motor with screws and washers.
8) Make the power wire connections with wires black to black, white to white and green to green or bare
wire(ground).Make sure that fan is properly grounded. Carefully push all wiring inside wiring box after
splices are made. The blue wire is provided for the connection of optional light kit. Do not connect this
wire if light is not installed.
06
Tabla de contenido
loading

Este manual también es adecuado para:

Vt-107bVt-rb131Vt-rm106Vt-105m

Tabla de contenido