Earlex SPRAY STATION GEMINI Manual De Instrucciones página 12

FF0084-A4-0312_Layout 1 09/03/2012 14:21 Page 12
Spraying - from the Quart Cup
Tip: Before starting your project, practice spraying onto waste cardboard.
1. Fill the 1qt paint cup with your coating material – and check dilution. DO NOT OVERFILL above the start of the threaded neck.
2. Push the pick-up tube (11) firmly into the base of the spray gun body. Screw the paint container onto the spray gun body tightly.
3. Set paint flow adjuster (8) to lowest setting (halfway between min & max).
4. Uncoil the Air Hose (15) and attach it to the back of the spray gun and the other end to the Earlex Spray Station Gemini. Uncoil the power cable and
plug in to the electrical outlet.
5. Turn the turbine on.
6. Fine tune spray output with paint flow adjuster on gun. ¼ to ¾ setting produces the best spray.
7. An airtight seal is essential for the correct operation of this spray gun. Before operating the unit please ensure that the gasket (9) is in place and the
quart cup (12) is securely fixed to the spray gun body.
Tip: If you are spraying a ceiling angle the pick-up tube (11) to the rear of the cup or if you are spraying a floor surface angle the pick-up tube to the
front of the cup. This will ensure you spray as much material as possible before you need to refill the cup.
As some paints, wood preservatives and other sprayable materials contain particles that have differing qualities or you may be using an old paint, we
recommend that you filter your material when filling the paint cup of the spray gun or backpack, through either a funnel with a filter on it or through
hosiery. This will ensure that no large particles enter the paint cup, so preventing blockages and providing you with trouble-free spraying.
ALWAYS MAKE SURE THAT THE PRODUCT IS ON A STABLE SURFACE AND FREE FROM DUST AND DEBRIS OR LIQUIDS.
ALWAYS KEEP THE PRODUCT AS FAR AWAY FROM THE SPRAYING AREA AS POSSIBLE TO PREVENT PAINT CONTAMINATING THE MOTOR.
MASK ANY AREA YOU DO NOT WISH TO SPRAY.
Cleaning Instructions - Spraying from the Quart Cup
Disconnect the Air Hose (15) from spray gun.
●
Remove the Quart Cup (12).
●
Pour any leftover paint into its container so that it can be used in the future. Pull the trigger to allow paint to run out of the pick-up tube (11).
●
Connect the air hose to the spray gun.
●
Pour a quantity of the respective thinner into the Quart Cup, reassemble the spray gun, then spray this liquid through the spray gun. Repeat this
●
until the thinner being sprayed is coming through with no traces of paint.
Clean any traces of paint off the outside of the spray gun.
●
Clean the paint container gasket (9).
Cleaning Instructions - Spray Gun
●
Unscrew Air Cap Ring (2).
●
Remove the Air Cap (3).
●
Remove the Spray Direction Plate (4).
●
Using the Needle and Fluid tip tool - pincer end A (1) remove the Fluid tip (5).
●
Insert the Needle and Fluid tip end B (1) into the inner tube and unscrew the Needle anticlockwise, then pull to release the Needle.
●
Place all of these items into a container and clean, using a brush and the respective thinners.
●
Small Projects - from the Quart Cup
(Water & solvent based coatings may be used with this
set-up.)
(Priming not required)
1) Uncoil the black air hose from around the bucket and put it to one side.
2) Fit the rigid suction tube (Fig.8) and paint container to gun (for first time use, the gun already
comes supplied like this).
3) Then fit the black air hose to head unit and gun using a TWIST motion.
DVD
12
DVD