Bending Conduit - Southwire MAXIS Xtreme MXB2000 Instrucciones De Operación

BENDING CONDUIT

Bending ½", ¾", 1", and 1 ¼" EMT, Rigid, and IMC Conduit
bender is disconnected from the power source.
2. Install the correct roller assembly on the bender and attach the hinge pin to
secure it to the bender. Insert the cotter pin into the end of the hinge pin.
3. Install the appropriate bending shoe for the conduit being bent
4. Place the black roller assembly in the folded-up or vertical position.
These rollers are used when bending ½", ¾", 1", and 1 ¼" conduit.
MXB2000 with Roller Supports in the UP-position for bending ½", ¾", 1", and 1 ¼" conduit
roller unit into the fully retracted position. The 1 ½" and 2" rollers should
drop into the fully retracted position. If they do not fully retract, use a tool,
such as a screwdriver, to adjust the roller so that both rollers rotate coun-
terclockwise to the retracted position. Using a tool to adjust the roller will
keep hands and fingers clear from any potential pinch points. These
pressure rollers are not used when bending ½", ¾", 1", and 1 ¼" conduit.
15
BENDING CONDUIT
6. The bending shoe is separated into two halves. One half of the shoe is
used for bending ½", ¾", 1", and 1 ¼" conduit. The other half of the
shoe is used for bending 1 ½" and 2" conduit. See markings cast into
the center of the shoe indicating the conduit size for each half.
Use this half for
8. Turn the power switch on the back of the bender to the ON position.
9. Using the pendant controller, press BEND to rotate the shoe clockwise.
Rotate the shoe until the ½", ¾", 1", and 1 ¼" half of the shoe is facing
bender. Place the conduit on the correct size roller and guide it into the
bender until it aligns with the corresponding groove in the shoe.
Continue guiding the conduit into the bender until the bending mark is
aligned with the front edge of the hook.
16
Use this half for
bending ½" ¾"1",
and 1 ¼"conduit