If your board leaks, always tighten the valve first. A loose valve leaks air between the
outer edge of the valve and the surface material of the board. If tightening does not
help and you cannot find the exact leak spot, spread water-detergent solution all over
the seams. The leaking area will bubble where air escapes the board. Mark the area,
deflate the board and clean the area well. Perform repairing outdoors or in a well-ven-
tilated area. Cut a patch from the spare PVC material included in the repair kit so that
the patch extends at least 3 cm in all directions around the leak. You can
roughen the area around the leak a little with sandpaper if you like.
You can get the glue by contacting customer service, or when retrieving your board
from the store. If your board leaks, always tighten the valve first. A loose valve leaks air
between the outer edge of the valve and the surface material of the board. If tightening
does not help and you cannot find the exact leak spot, spread water-detergent soluti-
on all over the seams. The leaking area will bubble where air escapes the board. Mark
the area, deflate the board and clean the area well. Perform repairing outdoors or in a
well-ventilated area. Cut a patch from the spare PVC material included in the repair kit
so that the patch extends at least 3 cm in all directions around the leak. You can
roughen the area around the leak a little with sandpaper if you like..
Glue precautions
• The adhesive is highly flammable, do not handle the adhesive near fire or sparks.
Smoking is strictly forbidden.
• Gluing must be done in well-ventilated area. The glue fumes are harmful to health
and can cause nausea.
• Keep the adhesive out of the reach of children and pets.
• Protect your hands and be careful not to get glue in your eyes, mouth, or skin.
• In case of contact with eyes, rinse immediately with plenty of water and seek medical
advice.
• Before completely dry, the adhesive is very harmful to the environment.
7 REPAIRING
EN
EN
15