Klarstein MONACO Manual De Instrucciones página 25

EN
Wait a few seconds until the water tank lid starts to release water into the basin.
You will hear a bubbling sound as the air enters the water tank. Plug the power
cord into the electrical outlet (NEVER SWITCH ON THE HUMIDIFIER WITHOUT
WATER lN THE BASIN). If the humidifi er is switched off, the values for humidity will
now be displayed.
Press the ON/OFF Button to activate the humidifier. The machine is now operating
in manual mode. It will release cool mist on a constant basis with the mist intensity
level automatically set to medium. The two jets at the top of the machine can be
rotated to blow mist in two directions. You may also lift the jets from the water
tank, adjust the positions and reinsert them back into the top of the water tank.
The output jets should not be set to spray directly onto people, electrical devices or
any obstructions. It is best to direct the jets into the open air.
The +/- Button changes the mist level (low, medium, high). This change is displayed
on the LED screen by the mist volume indicator (#21). If the machine is in the
automatic mode, it will automatically adjust the mist intensity.
Pressing the SETUP Button activates automatic mode (when the LED display starts
to blink the word ‚Auto'). You can select the desired humidity level by pressing +/-
Button repeatedly until the required humidity level is displayed (from 45% to 90%
in increments of 5%). Once you select your desired humidity
level, simply stop pressing the button and you humidity level will be set. Wait
another 5 seconds and the numeric value on the LED display will switch to the
current humidity level as measured by the built-in Hygrostat. When the humidity
level in the room reaches the set humidity level, the machine will go into automatic
sleep state and stop producing mist. When the rooms actual humidity level drops
below your set humidity level, then the machine will start producing mist again.
You can deactivate automatic mode very easily by pressing the setup button until
you reach 90% RH. Press the button one more time and you will now be in the
manual mode. You will know that you are in the
manual mode because the blinking 'Auto' Icon disappears.
Pressing the Ion Button will activate the ion generator and start sending healthy
ions into the air. it will be represented by the tree icon (#19) displayed on the LED
25