Troubleshooting - Sage Nutri Juicer Plus BJE520 Guía Rápida

Troubleshooting

POSSIBLE PROBLEM
Machine will not work when
switched ON
Motor appears to stall when juicing
Excess pulp building up the Stainless
Steel Filter Disc
Pulp too wet and reduced
extracted juice
Juice leaks between the rim of the
juicer cover
Juice sprays out from spout
When using the Froojie extractor, the
®
filter bowl surround becomes full and
clogs its spout
Overheating with excessive loads.
EASY SOLUTION
• The safety locking arm may not be correctly engaged in the vertical
operating position with the locking arm located into the two grooves on
either side of the juicer cover.
Wet pulp can build up under the juicer cover if the juicing action is too
•
vigorous. Try slower juicing action by pushing the food pusher down more
slowly. Follow cleaning instructions and clean the filter bowl surround, the
juice disc and the juicer cover.
The juicer will automatically stop operating if the motor is stalled for more
•
than 10 seconds. Either too much food is being processed at one time
or the pieces are not small enough. Try trimming the food or cutting into
smaller pieces of even size and processing a smaller amount per batch.
To continue juicing, reset the juicer by pressing the ON / OFF switch on
the control panel to OFF then turn the appliance back on by pressing
ON / OFF switch to ON.
Hard fruits and vegetables will put excess strain onto the motor if a low
•
speed is selected. Please refer to the juicing guide to determine the
correct speed for the fruits and vegetables selected for juicing.
• Stop the juicing process, remove the juicer cover, scrape off pulp,
reassemble and begin juicing again. Try alternating (soft and hard)
vegetable and fruit varieties.
Try a slower juicing action.
•
• Remove juice disc and thoroughly clean mesh walls with a cleaning
brush. Rinse the juice disc under hot water. If the fine mesh holes are
blocked, soak the basket in a solution of hot water with 10% lemon juice
to unblock the holes or wash in the dishwasher.
This will remove excess fibre build up (from fruit or vegetables) which
could be inhibiting the juice flow.
Try a slower juicing speed and push the food pusher down the feed chute
•
more slowly.
Use juice jug and lid provided, or if juicing into a glass use the custom
•
designed juice nozzle.
Try using fruits with more water content to help flush through the contents.
•
Additionally, try a slower juicing action by feeding one piece in at a time
and by pushing the food pusher down more slowly.
Try using fruits with more water content to help flush through the contents.
•
Additionally, try a slower juicing action by feeding one piece in at a time
and by pushing the food pusher down more slowly.
The juicer is fitted with a safety device which safeguards against
•
overheating with excessive loads. If overheating occurs, the juicer will
automatically activate the overload protection device and the unit will
switch itself off. When the overload protection is activated, unplug the
juicer from the power outlet for at least 15 minutes to allow the unit to cool.
Then plug the juicer into the power outlet and use as normal.
EN
11