KALLISTA P29513-00-NA Instrucciones De Instalación página 7

Install the 2-Way Valve
Install 1/2" copper tubing or piping for both accessories. Securely fasten the piping
and outlet elbows to the framing.
Install temporary 1/2" nipples in the outlet elbows so that they extend a minimum
of 2" (51 mm) beyond the finished wall.
IMPORTANT! For P29513: Water should flow as follows: Accessory 1, Accessories 1
and 2, Accessory 2. If water flows as: Accessory 2, Accessory 2, Accessories 1 and 2;
remove the spacer, rotate the detent 180 degrees, then reinstall the spacer.
NOTE: For P29514: When the valve is turned midway between the two outlet ports,
water flow from the ports will reduce to a trickle.
Turn ON the water supply to the valve.
Check for leaks and proper operation.
Turn OFF the water.
Install caps on the temporary bath and shower nipples.
Turn ON the water supply and check for leaks.
Turn OFF the water.
Complete the finished wall.
Remove and discard the plaster guard.
Install the trim according to the instructions provided with the trim.
Kallista 7
1491214-2-A