Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3 .
Position the tool on the tongued edge of the flooring strip aligning the driver guide (C)
against the front of the flooring strip .
4 .
Strike the rubber cap (B) with the rubber end of the mallet (F) . The tool will then drive
the cleat/staple at the correct 45 degree angle .The proper length of flooring cleat to use
with various thicknesses of flooring . Repeat this process until the job is completed .
COLD WEATHER OPERATION
When operating tools at temperatures below freezing:
1 .
Make sure compressor tanks have been properly drained prior to use .
2 .
Keep tool as warm as possible prior to use .
3 .
Make certain all fasteners have been removed from magazine .
4 .
Put 5 to 7 drops of PORTER-CABLE pneumatic tool oil in the air inlet .
5 .
Lower air pressure to 80 psi (5 .5 bar) or less .
6 .
Load nails into magazine and reconnect air .
7 .
Actuate the tool 5 or 6 times into scrap lumber to lubricate O-rings .
8 .
Turn pressure up to operating level (not to exceed 120 psi) and use tool as normal .
9 .
Re-lubricate at least once daily .
10 . Always drain the compressor tanks at least once a day .
HOT WEATHER OPERATION
Tool should operate normally . However, keep tool out of direct sunlight as excessive heat
can deteriorate bumpers, O-rings and other rubber parts resulting in increased maintenance .
To reduce the risk of personal injury, disconnect tool from air
supply before performing maintenance, clearing a jammed fastener, leaving work
area, moving tool to another location or handing the tool to another person.
DAILY MAINTENANCE CHART
ACTION
Lubricate tool
with 5-7 drops of
PORTER-CABLE
Pneumatic Tool Oil
Drain compressor
tanks and hoses daily
Clean magazine,
magazine release
and contact trip
mechanism .
Before each use,
check to insure all
screws, nuts and
fasteners are tight
and undamaged .
CLEANING
When cleaning, use only mild soap and a damp cloth on plastic parts . Many
household cleaners contain chemicals which could seriously damage plastic . Also, do not use
MAINTENANCE
WHY
Prevents failure of o-rings
Prevents accumulation
of moisture in
compressor and nailer
Permits smooth operation
of magazine, reduces
wear and prevents jams .
Prevents jams, leaks
and premature failure
of tool parts .
HOW
Insert drops into air fitting
on end cap of tool
Open petcocks or other
drain valves on compressor
tanks . Allow any accumulated
water to drain from hoses
Blow clean with compressor
air . The use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris .
Tighten loose screws or other
fasteners using the appropriate
hex wrench or screwdriver .
9 - ENG
Tabla de contenido
