Approval Of The Receiver; Rack Mounting - IMG STAGELINE BXL-DR10 Manual De Instrucciones

•
Immediately disconnect the power supply unit
from the mains socket
1 . if the receiver or the power supply unit is vis-
ibly damaged,
2 . if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the units must be repaired by skilled
personnel .
•
For cleaning only use a dry, soft cloth, never use
chemicals or water .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other pur pos es than originally intended, if they
are not correctly connected or operated, or if
they are not repaired in an expert way .
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment .
3 Applications
In combination with a wireless microphone, the
multi frequency receiver TXS-871 makes up a
wireless audio transmission system which is ide-
ally suited for musicians and live performance on
stage . The wireless transmission of music or speech
to the audio system ensures the musician's freedom
of movement during the performance .
The True Diversity* receiver operates in the UHF
frequency range of 863 to 865 MHz . Within this
range, the audio transmission frequency can be
selected from 15 frequencies (frequency spacing
125 kHz) .
The following transmitters from the product range
of IMG STAGELINE can be used:
– TXS-871HT (order no . 25 .3610)
Hand-held microphone with integrated multifre-
quency transmitter
– TXS-871HSE (order no . 25 .3620)
Multifrequency pocket transmitter, suitable for
connecting a headband microphone or a tie-clip
microphone
* True Diversity: The signal sent is received by two
antennas and amplified in two separate receiver sections .
The signal of the highest reception quality is then processed .

3.1 Approval of the receiver

Herewith, MONACOR INTERNATIONAL declare that
the receiver TXS-871 complies with the directive
2014 / 53 / EU . The EU declaration of conformity is
available on the Internet:
www .monacor .com
The receiver is generally approved for operation
in EU and EFTA countries; it is licence-free and
requires no registration .

3.2 Rack mounting

To insert the receiver into a rack designed for units
with a width of 482 mm, use the holder RCB-870
(order no . 24 .2830) which is available as an ac-
cessory . The holder supports up to two receivers
and requires a height of 1 rack space (= 44 .5 mm) .
4 Connection
1) Insert the two supplied antennas (6) into the
BNC antenna jacks ANT . 1 and ANT . 2 (11) and
put them in a vertical position .
Hint: To increase the transmission range and the inter-
ference resistance, it is possible to use the pair of an-
tenna signal amplifiers TXS-875B (order no . 15 .0840)
available as an accessory . The amplifiers are supplied
with power via the antenna jacks of the receiver .
2) For connecting the subsequent unit (e . g . mixer)
the receiver is provided with two audio outputs:
– AF OUT . BAL . (10)
balanced XLR output for con necting a bal-
anced microphone input
– AF OUT . UNBAL . (9)
unbalanced 6 .3 mm output jack, for connect-
ing a line input (a matching connection cable
is supplied with the unit)
If the subsequent unit is provided with a bal-
anced microphone input, the XLR output should
be used for an optimum signal transmission .
Make the corresponding connection to the
subsequent unit . Do not switch on the subse-
quent unit or do not advance the corresponding
fader on the mixer before the microphone sys-
tem has completely been switched on .
3) For power supply, connect the power supply
unit provided to the power supply jack (8) and
to a mains socket (230 V/ 50 Hz) .
9