Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2WD Buggy DAZZLER
RC-system
Transmitter does not work pro-
perly
Transmitter range is too small
Servos do not work properly
RC transmitter does not work well
while the engine is running
Chassis
Model pulls to one side
Model can be controlled but only
with difficulty
Poor braking
Clutch does not engage
Clutch does not disengage
Model does not function
Damping not functioning
Shock absorbers lose oil
Model rolls over towards the back
during acceleration
No. 103003
09/06
All manuals and user guides at all-guides.com
Transmitter and/or receiver batteries are
empty
Batteries are inserted wrong
Plug from the receiver battery is loose
Poor reception
Transmitter and/or receiver batteries are too
weak
Transmitter antenna is not pulled out
completely
Receiver antenna is not pulled out completely
Receiver antenna is cut
Transmitter and/or receiver batteries are too
weak
Gear wheels inside the servo gear do not
engage or are defective
Adjusting ring at the steering levers are loose
Receiver crystal is loose
Plug from the receiver batteries is loose
Poor reception
Receiver damaged, e.g. after a crash
Steering trim is misaligned
Alignment right and left is different
Wheel damaged on one side or bearings
defective
Servo links not properly adjusted
Receiving power of the antenna is too small
Batteries of transmitter and/or receiver empty
Brake linkage misaligned
Clutch shoes worn out or defective
Clutch bell worn out or defective
Fly wheel is loose
Spring for clutch shoes worn out or defective
Main pinion defective
Damaged pinions in the differential
Centrifugal clutch set too loose
One or more dampers are jammed
Piston rod bent
A damping component is defective
Sealings worn out
Centrifugal clutch set too taut
Replace the transmitter and/or the receiver
batteries
Test the polarity of the batteries
Plug-in the plug firmly
Receiver antenna is not pulled out completely
Replace the transmitter and/or the receiver
batteries
Pull out the antenna completely
Pull out the antenna completely
Let repair the receiver antenna
Replace the transmitter and/or receiver batteries
Let repair the servo
Fix the adjusting rings again, use the standard
settings
Put-in the receiver crystal again
Plug-in the plug again
Receiver antenna is not pulled out completely
Repair the receiver
Correct the neutral position on the remote control
Reset the alignment on both sides to 0
degrees.
Remove the wheel, clean the bearings and, if
necessary, replace
Place servos in neutral position and readjust
Pull out the antenna of the transmitter completely.
Completely unwind the antenna of the receiver
and guide it upwards
Replace batteries or recharge rechargeable bat-
teries
Correct the adjustment of the brake steering lever
Brake disc worn out Replace brake disk
Replace clutch shoes
Replace clutch bell
Retighten fly wheel.
Replace springs
Replace main pinion
Replace pinions
Reset centrifugal clutch
Clean and/or disassemble dampers
Repair the piston rod
Check and replace the corresponding part
Replace sealings
Loosen the adjusting screw until the model runs
smoothly
37
Tabla de contenido
