Eldom atma NU40 Manual De Instrucciones página 11

GENERAL DESCRIPTION
1. Nozzle
2. Cover
3.
Water tank
4. Control panel
5. Lamp
6.
Float 1
7. Float 2
8. Control tube
9.
Air outlet
10. Oil reservoir
11. Maximum water level indicator
12. Ultrasonic transducer
13. Remote control
INTENDED USE
The ultrasonic humidifier NU40 is designed to improve air quality in living quarters. The appropriate level of air humidity improves
the well-being and quality of sleep. Additionally, it is equipped with an aromatherapy function - the device can be used with
aromatic water additives intended for humidifiers.
Natural air ionization, resulting from the breaking of water particles, additionally cleans the humidified air and reduces the amount
of bacteria present in it.
USE
- Before use, check that the appliance is complete and undamaged.
- Do not place the appliance on a carpet, lining, parquet floor, or any surface which can be damaged by water or moisture.
- It is recommended to place the humidifier at a minimum height of 1 m from the floor.
- Fragrant-water additives (oils, etc.) for humidifiers may be used with the appliance. The
essential oil can only be poured on a sponge, which is placed in a reservoir (10).
WARNING. Pouring the oils directly into the tank (3)) can damage the humidifier. Such
damage is not subject to warranty repair.
OPERATION
- Make sure the appliance is turned off and disconnected from the power supply.
- Remove the nozzle (1) with one hand on the tank (3) and remove the lid (2).
- Insert a tube (8) into the container – Fig. 1 and push the float (7).
WARNING. The device may only be switched on if a hose (8) with float (7) is fitted.
- Fill the tank (3) with water to the maximum level (11).
- Place the lid (2) on the container (3) and the nozzle (1) on it.
- Plug the appliance into the mains, complying with the parameters specified above. The
appliance will enter the stand-by mode. No function is active, and the display is switched off.
All changes in the settings are confirmed with an audio signal.
ON/OFF (SWITCHING ON / SWITCHING OFF)
Pressing the button (A) will cause the display to activate. The humidifier will start running at the highest level of humidification,
with the fan motor running. The humidity level is displayed. Pressing the button (A) again will switch off the unit and make it enter
the stand-by mode.
HUMIDITY (MIST)
The appliance is fitted with a three-stage control of humidification. The level of humidification is changed with the button (B).
Changes are displayed with the numbers 1 to 3 on the display.
HYGROSTAT (HYGROMETER)
This function allows to set the level of humidity from 45–90% in 5% steps. The appliance will start after about 3 seconds of entering
INSTRUCTION MANUAL
ULTRASONIC HUMIDIFIER NU40
CONTROL PANEL (4) / REMOTE CONTROL (13)
A. ON/OFF
B. HUMIDIFY
C.
HYGROSTAT
D. TIMER
E. SLEEP
F.
NIGHT LIGHT
TECHNICAL DATA
- power: 27 W
- supply voltage: 220-240V ~ 50-60 Hz
- capacity: 2,8 l
- output: 200 ml/h
- humidifier output for a 35m2 room
- humidifier operation time for a full
container: approx. 14 hours
EN
1
11