Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SHINE reserve parachute's manual SHINE
The reserve parachute installation will vary relative to the riser type used. Please review the following recommendations :
- « Y » risers setup. >>Two (2) 6mm Maillons Rapides® are needed ( Ref. : MAILCARIN6 ) + two (2) toric elastic rings ( Ref. : MPPP044 ).
- Separate STD risers ( Ref. : ELESOLOSTD ). >> One (1) square 7mm Maillon Rapide® will be needed ( Ref. : MAILCARIN7 ) + four (4) flexible toric rings (
Ref. : MPPP044 ).
Follow the instructions corresponding to the type of risers you intend to use.
1. Reserve parachute to harness connection with « Y » risers.
>> « Y » riser reserve parachute connection.
Make a loop to loop ( Lark's head ) knot between the single reserve parachute riser and the base of the « Y » riser where the
bigger bridle diameter loop is located.
>> « Y » riser connection to the harness.
1.
- Take two (2) square 6mm Maillons Rapides® and two (2) flexible toric rings.
- Unfasten the Velcros (or zip) located alongside the shoulder protective sleeves to reach the reserve parachute connection
loops on the shoulder straps.
2.
- Open the Maillon Rapide®- Push
the bridle's buckle through.
- Push the maillon through the flex-
ible toric ring.
- Twist
7.
Tuck away the risers excess ( without making knots ) under one
6.
Repeat sequence
single flap :
1 through 5 on the
other side of the
- Either to the right side if you wish to place your reserve parachute
harness.
handle to the right ( recommended if right handed ).
- Or to the left side if you wish to place your reserve parachute
handle to the left ( recommended if left handed )..
- Close the protective sleeves Velcros (or zip).
Connecting the reserve parachute to the harness
3.
- Push the riser's loop
through the flexible toric ring.
- Push the maillon through the
riser's loop.
4.
- Give a second twist to the
toric ring.
- Push the Maillon Rapide®
through the riser loop.
5.
-
Tidy up the assembly.
- Be certain that the risers end loops
are securely in place.
- Close the maillon tightly by hand.
- Complete tightening with pliers by
making a ¼ tightening turn.
SUP'AIR
_SHINE
Page 10
Tabla de contenido
