Using The Device - Parkside PSHL 2 D1 Instrucciones De Funcionamiento Y De Seguridad

The response time of the filter
will slow down if the temper-
atures go below/above these
temperatures.
Clean the filter, helmet surface
„
and the solar cells regularly.
Replace the protective visor if
„
it showing signs of scratches
or damage.
The welding helmet does not
„
protect against impact.
Using, cleaning and storage
„
can reduce the service life of
approx. 5 years. If the viewing
pane is scratched or there is
other visible damage to the
viewing pane or the welding
helmet, replace immediately.
ATTENTION! Materials which
come into contact with the skin
of the wearer can cause allergic
reactions for sensitive individuals.
ATTENTION! Eye protection
equipment against high-speed
particles can pose a danger
for the wearer through transfer
of impact if they are worn over
standard prescription glasses.
ATTENTION! If protection
against high-speed particles at
extreme temperatures is neces-
sary, the selected eye protection
equipment must be marked with
the letter T in accordance with
the letters relating to impact
intensity, i.e. FT, BT or AT. If the
letter for impact intensity is not
followed with the letter T, the eye
protection equipment must only
be used at room temperature
against high-speed particles.
z Using the device
Note: Only use the welding helmet with the
rear lens fitted.
4
Note: Keep the arc sensors
filter clean.
8
After opening the package, immediately
check to ensure that the package contents
are complete and are in perfect condition.
Contact your dealer immediately if the
package contents is incomplete or has
any defects. Do not use the device if it is
defective.
Before using the welding helmet each
time, you must check that the protective
screen as well as the helmet is intact. If
the protective screen should show signs of
scratches, cracks or unevenness, then it is
essential that it is replaced before use, as
otherwise this could lead to serious injuries.
Remove the protective film from the
„
inside and outside of the visor.
Adjust the welding helmet with the help
„
of the headband
dial on the headband
adapt the welding helmet to the respec-
tive head size and the lateral control
dials on the headband
welding helmet. During the set-up, make
sure the welding helmet is positioned as
low as possible on the head and as close
GB/IE/NI/CY/MT
of the UV
17
. Turn the rear control
5
in order to
6
to lock the
7
11