Checking The Battery; Safety Checks; General Safety Check; After Use - Stiga T 300 Li 20 Serie Manual De Instrucciones

6.1.1

Checking the battery

Before using the machine for the first time after purchase,
fully charge the battery following the instructions in the battery
booklet.
Before every use of the machine, check the battery charge
status according to the instructions in the battery booklet.
Do this when the cutting means is stationary.
6.2

SAFETY CHECKS

Always carry out the safety checks before use.
6.2.1

General safety check

Object
Grips
Handle
Cutting means
Control lever
Battery
Screws/nuts on the machine
and on the cutting means
Cooling air ducts
Machine
Action
1.
Start the machine (par.
6.3 ).
2. Release the control
lever (Fig.4.A).
Result
Clean, dry.
Fixed firmly to the machine.
Clean, not damaged
or worn, intact, well-
sharpened.
The lever must move
freely, it must not need
forcing and should return
automatically and rapidly
back to the neutral position.
No damage to the casing,
no liquid leakage.
Correctly tightened
(not loose). Not
damaged or worn.
Not clogged
No signs of damage
or wear.
No abnormal vibrations.
No abnormal sound.
Result
1.
The cutting means
should move.
2. Don't force the safety
lever as it must move
freely; it should return
automatically and
rapidly back to the
neutral position, re-
sulting in the stopping
of the cutting device
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
a service centre to have it checked and repaired if nec-
essary.
6.3 IGNITION
NOTE Ignite the machine on a level surface,
without obstacles or high grass.
1. Open the battery housing hatch (Fig. 5.A)
2. Insert the batteries correctly in the
battery compartment (Fig. 5.A) pressing
down until you hear them click firmly into
position, ensuring electrical contact.
3. Insert the safety key (fig 5.C).
4. Completely close the hatch again.
5. Engage the cutting means by first pressing the
safety button (Fig.4.A.1) and then pressing
the operator presence lever (Fig. 4.A).
Ignition of the motor simultaneously engages the
cutting means.
6.4 WORKING
IMPORTANT When working, always keep a safe distance
from the cutting means, given by the length of the handle.
Battery power reserve (and therefore the movable lawn
surface before recharging is required) depends on many
factors described in (par. 7.1).
IMPORTANT If the motor stops while mowing due to
overheating, you must wait approximately 5 minutes before
restarting it.
6.5 STOP
To stop the machine:
• release the operator presence lever (Fig 4.A)
• wait until the cutting means stops.
When you have stopped the machine, it will take a
few seconds for the cutting means to stop.
IMPORTANT Always stop the machine.
• When moving between work areas.
• When driving on grass free surfaces.
• Every time it is necessary to overcome an obstacle.
6.6

AFTER USE

1. Open the hatch and remove the safety key.
2. Remove the battery from its housing and recharge it
(par.7.1.2).
3. Allow the motor to cool before storing in an enclosed
space.
4. Carry out the cleaning (par. 7.2).
5. Check there are no loose or damaged components.
If necessary, replace the damaged components and
EN - 5