Candy CSTG 48TME/1-S Manual De Instrucciones página 111

5
The washing machine should be
l
connected to the water mains via the
new tube supplied
appliance (inside the drum). Do not
use the old tube for this purpose.
Connect one end of the water inlet
l
pipe with the elbow bend to the
electrovalve (top rear part of the
machine) and the other end to a tap
or a plumbed-in 3/4" gas threaded
connection.
Place the washing machine close to
l
the wall, ensuring that there are no
bends or kinks anywhere in the tube.
Hook the outlet pipe to the edge of
the sink or preferably to a fixed
drainage outlet of a diameter greater
than that of the outlet pipe and at a
height of min. 50 cm. and a
maximum of 75 cm. from the floor
(fig. 4).
If necessary, use the curved*
l
accessory to attach and support
the outlet pipe more securely.
If your model offers this function:
To move the washing machine
l
easily, turn the trolley lever to the
right. Once you have finished
moving the machine, return the lever
to its original position.
Level the machine by adjusting the
l
front feet (fig. 5).
a) Turn the nut clockwise to release
the screw on the foot.
b) Raise or lower the foot by rotating
with the
it until it stands firmly on the floor.
c) Lock the foot in position by turning
the nut anticlockwise until it comes
up against the bottom of the
washing machine.
Check that the appliance is properly
l
levelled.
Check that the washing machine
l
does not rock by trying to move two
diagonally opposite top corners at
the same time.
If you move the washing machine
l
from one place to another, you must
level the feet again afterwards.
111