Nacon CLOUD GAMING CONTROLLER Manual De Instrucciones página 5

I Using the controller via its USB receiver
The Cloud Gaming Controller is a plug'n'play device. In other words, the driver will be
installed automatically the first time you connect it to the PC.
Detailed procedure:
1. Turn on your PC and wait for it to start. Then log in to access your Windows desktop.
2. Connect the USB receiver supplied with the controller (or the USB cable) to a free USB
port on your PC.
3. The PC will then detect the new device and a few seconds later, the driver installation
process will start (you will then notice a small icon at the bottom right of your screen to
indicate this).
Note: The installation time will depend on your PC. When the installation is complete, the icon will change.
You can now on use your controller.
I Phone holder
A smartphone holder is provided with your controller. You will need to fit it to your controller
and make sure that it is securely fastened before inserting your smartphone.
To install the phone holder, follow these steps:
1. Slightly loosen the hinge so that you can unfold the phone holder from its clip to the
controller.
2. Unclip the opening system located on the bottom and open up the clip.
3. Insert your controller and close the clip. Make sure that the closing system is properly
clipped in.
4. Adjust the angle of your phone holder as required and tighten the hinge screw.
5. Unfold the holder base and insert your phone by pushing the upper part using your phone.
EN /